Package Include:

1x 3D touch probe

1x Stainless steel probe tip

1x cable






Specification:

Power: DC5-24V

NPN-NO 3 wires: Red-VCC (DC5-24V power);Yellow: IO/ Signal Output;Black- GND(DCM)

Repeatability Accuracy: 0.01 mm/ 0.0004 in.

Feedrate: 50-200 mm/min.

Approach Direction: ±X, ±Y, +Z.

Over Travel Protection Distance: X- ± 4mm/0.16 in , Y- ±4mm/ 0.16 in, , Z- 2mm/ 0.08 in.

Lifetime: > 3 million triggers.



Software Recommendation for 3D Probe

If you are using a mach3 system, it is recommended to use the open source Probe Wizard.

If you are using the grbl system, it is recommended to use Grblgru








Q&A

1.Need to turn on the spindle speed?

Never, never, never,definitely no.



2.How to distinguish the three wires?

The red wire is VCC, the black wire is GND, and the white wire is IO.



3.Why is the concentricity different every time the probe is installed?

Because your ER chuck spring clip cannot guarantee 100% uprightness. Every time the probe is installed, even if the concentricity is adjusted to 1 wire, there will still be deviations when the probe is removed and installed again. So your chuck is best to buy AAA and above accuracy (concentricity <=0.005), because many chucks in China have false standards, it is recommended to use a high-precision gauge or tungsten steel rod to check the table after installing the chuck. Look at concentricity. It's best to place the dial indicator at a distance of 50mm from the chuck, which is roughly the distance between the ball head of our probe and the root of the tool handle.