Specification:
These ports are for connecting the receiver to various models and flight controllers
PPM signal port: Outputs standard PPM signal.
I-BUS/S.BUS signal port: Outputs i-BUS/S.BUS signal, up to 18 channels.

Binding
1.Power on the receiver while holding the bind button. If the receiver’s LED is flashing this means it has entered bind mode.
If binding is successful the receiver’s LED will begin to flash slower.
2.On the transmitter, manually exit the binding menu. Once you have exited the bind menu the receiver’s LED will stop flashing and remain solid.
3.Check to make sure the model and receiver work as expected. If anything does not work as correctly, restart this procedure from the beginning.

Change i-BUS/S.BUS mode
When turned on and bound, the transmitter and receiver can change output mode to i-BUS and S.BUS modes by pressing and holding the bind button for 2 seconds.
LED turns off for 1 second then flashes twice: i-BUS output mode active.
LED flashes twice then turns off for 1 second: S.BUS output mode active.

Description:
Channels: PPM 8CH, i-BUS 18CH
Model type: Multi-rotor
Frequency range: 2.408-2.475GHz
Band width: 500KHz
Band number: 135
RX Sensitivity: -92 dBm
2.4GHz system: AFHDS 2A
Modulation type: GFSK
DSC port: PPM/i-BUS/S.BUS
Transfer method: FHSS
Data output: 1.5mm*3 Pin PPM/i-BUS/S.BUS
Antenna length: 26mm (Not including brass contacts)
Input power supply: 4.0-8.4V
Display method: LED
No ground interference ( Transmitting and receiving 1 m from the ground): >300m
Working current: 40mA
Each channel data: depend on the transmitter
Channel delay: <15mS
Compatible Transmitter: Compatible with FS-i4, FS-i6, FS-i6S, FS-i6X, FS-i10, FS-GT2E, FS-GT2G, FS-GT2F

Package Included:
1X FS-A8S V2 2.4G 8CH Mini Receiver