Funciono perfecto, solo se ajusto para que quemara lo nesesario y como era a juego con el multiple no fue dificil Read more

Went on and worked. My old carb Had a dead spot nobody could get rid of. Av2 Fixed my engine right out of the box. Read more

Runs perfect right out of the box. A little tweeking and it’s even better. Great solution if your tired of other peoples used junk Read more

I swapped out old quadrajet for this on a 305sbc in my c10. Right out of the box fired up and ran better than ever. After test drive and minor adjustment on idle air screws with vacuum gauge its like i have a hole..... Different truck! Better throttle response sounds different and gets to higher rpm's without hesitation. Was I was constantly struggling with the quadrajet to get rid of hesitation. Should have got one years ago!! It's minor adjustments for throttle linkage and kickdown cable/choke/fuel line,installed in about 2 hours Read more

Love thus carburetor, out of the box starts and runs well even on a big block chev on a cold day starts and idles nice, minor tuning gets it humming well. Great investment Read more

The annular flow boosters really do improve throttle response. Feels just like a fuel injected car. Very easy to tune as well. Read more

First dealings with Amazon, looking for more parts to buy. Hopefully they have more quality gear than some of Ebay. Read more

シボレーSBC350に搭載の♯1406から交換したしました。 まだセッティングの途中ですが全域に渡りとても良い感じです！ まだ国内にセッティングパーツやリビルトキットが出回ってないのでこの点の手配が少し心配ですがいずれ何度かなるでしょう！ とにかくキャブレターの性能は素晴らしいです！ Read more

I bought this carb to replace a Holley. I've always had Holleys on the 351M in my truck, but decided to try the Edelbrock because of the fuel delivery method on the AVS2. I could not be more pleased with the improvement. The Edelbrock responds immediately to the gas pedal. It does not stumble at all and accelerates smoothly and strong. The overall performance has improved dramatically since installing this carb. The engine is also running much more smoothly and even the exhaust tone is better than with the Holleys. To be fair, my guess is that I was just never able to get the Holleys tuned just right so this is not being critical of Holley carbs. I just lack that skill set to tune those carbs and the Edelbrock seems to be good out of the box. I only had to make slight adjustments to the idle speed screws. Another plus for me is that the Edelbrock is wider but not as deep as the Holleys. I have an electronic distributor that is larger than the OE distributor and with the Holleys it has always been really tight between the carb and the distributor. With the Edelbrock, I have at least an inch or so between them. It makes adjusting timing easier. I also added the Edelbrock 9265 heat insulator gasket which lifts the carb maybe a 1/4 inch which also helps with clearance. I gave it a 3 for installation ease because on the Fords it requires another kit (1483) for the C6 automatic transmission kick down bar to attach to the carb. It took some adjusting and getting a longer adjustment screw for this, but with some tinkering it works perfectly. Nothing really hard about the install, but it does require some fiddling to make everything work smoothly on the Ford. I'm extremely pleased with this purchase. Read more

Buenas noches el producto es excelente. Solo que no se donde o por qué medio preguntar si también tienen la base soporte para el Cable del acelerador la que va en el motor . El motor es un 350 5.7 L ? Read more

New and works great Read more